Analysis of the Three Types of SCSI Interfaces
Nov 20, 2026
The SCSI interface is generally divided into SCSI-1, SCSI-2 and SCSI-3. Each type of SCSI has its own unique characteristics and application scenarios.

I. SCSI-1
Basic Characteristics: SCSI-1 is the earliest version. Its asynchronous transmission frequency is 3MB/s, and the synchronous transmission frequency is 5MB/s. Although this version has almost been obsolete, it can still be seen in certain specific devices such as scanners and internal ZIP drives.
Interface Type: SCSI-1 uses a 25-pin interface. When connecting a SCSI-1 device to a SCSI card, an internal 25-pin to 50-pin interface cable is required. For external devices, none of the internal interfaces can be used.
Application Scenarios: Due to its slow transmission speed, SCSI-1 is mainly used in devices with low requirements for data transmission rate.
II. SCSI-2
Basic Characteristics: The early SCSI-2 is called FastSCSI. It increases the synchronous transmission frequency from the original 5MB/s to 10MB/s and supports 8-bit parallel data transmission, allowing for the connection of 7 external devices. Later, WideSCSI emerged, which further supports 16-bit parallel data transmission, with a data transmission rate of 20MB/s and the ability to connect 16 external devices.
Interface Type: SCSI-2 uses a 50-pin interface, mainly applied in scanners, CD-ROM drives, and old-fashioned hard drives.
Access Control: SCSI-2 introduced access control mechanisms such as Reserve (reservation), Release (release), and Reset (reset). When accessing a lun, the client needs to perform a reservation operation first, and after success, obtain the access permission to the lun. However, there are some drawbacks to the access control of SCSI-2, such as reservation based on the path, inability to retain the reservation for a long time, and the fact that a lun reserved by one host cannot be reserved by another host anymore.
Application Scenarios: Due to the improvement in data transmission rate and the increase in the number of connected external devices, SCSI-2 was widely used in computer systems at that time.
III. SCSI-3
Basic Characteristics: SCSI-3, also known as UltraSCSI, was born in 1995. It increases the synchronous transmission clock frequency to 20MB/s (if using the Wide mode with 16-bit transmission, the data transmission rate can be increased to 40MB/s), significantly improving the data transmission rate. This version of SCSI uses a 68-pin interface and is mainly applied in hard drives.
Various Models: SCSI-3 includes various models such as Ultra(fast-20), Ultra wide, Ultra 2, Ultra 160, Ultra 320, and Ultra 640, with data transmission rates ranging from 20MBps to 640MBps.
Access Control: SCSI-3 introduced Persistent Reserve (PR) and PREEMPT (preemption) mechanisms. Before accessing a lun, the client needs to register a reservation key with the lun and attempt to perform a permanent reservation. Unlike SCSI-2, the release operation of SCSI-3 is based on the reservation key. Additionally, the client can obtain the access permission to a reserved lun through preemption, and the preemption operation will not cause data loss.
Application Scenarios: Due to the significant improvement in data transmission rate and the improvement of access control mechanisms, SCSI-3 has been widely used in high-performance computer systems and storage systems.
In conclusion, the three types of SCSI interfaces each have their own characteristics and application scenarios. With the continuous development of technology, SCSI interfaces are constantly evolving to meet the requirements of different fields for data transmission rate and connection performance.







